Installing electronics on a kayak can bring on many challenges. One of the major challenges are how to wire through the kayaks bulkhead and what products are manufactured to cap large drilled holes post wiring the fish finder. This article covers common Types of Hull Pass-Throughs.
After a lot of research here are a few types of hull pass-through caps for wiring electronics on your kayak.
Commonly used for drain plugs and scupper holes the Rubber stopper can also be used for Thru Hull Wiring. Simply with a sharp box cutter cut a slit from the outer diameter to the center hole. This will allow you to pass the wire into the center of the stopper. Runt he connecting plug through the hole and simply press the stopper in small diameter of the flange first to make a seal. This method works but is not recommended for a permanent install. The stopper over time can come loose so check it every now and then. It wouldn’t hurt to silicone them in.
The cable gland is a wiring connector that is able to match wire diameters with a grommet that seals tightening down a lock nut.
On the bottom of the gland is a threaded portion that is able to pass through a drilled hole in the hull and tightened down with an included ring nut. Cable glands do work great but the only problem i see with them is the protrusion they create. They are easily snagged by fishing line. In areas that fishing line will not snag they are great.
Cable clams are a good solution but protrude the most. They require 4 large screws holes perfectly aligned. Personally I think they are the most unsightly for applying on a kayak. They are purposed more for boats. They are also the most expensive and hardest to install.
The CeaCap is the most flush option but will only work with cable plugs that will pass through a 3/4″ hole. It is threaded and will turn the wire 90 degrees so it is flush with the hull. IT will allow for two 12 gauge wires to pass through.
The best out of them all I have found for large connectors is the West Marine Wire Cap. Fish finder connectors with 1″ diameter will work with this cap to cover the required hole to pass through the wire for both the transducer and the power. You may run two wires at 14 gauge through this cap max and 1 wire at 8 gauge id say max.
Like this:
Like Loading...
