oct24windPrior to going out on any event/tournament its a good idea to check the weather forecast prior to packing. This allows you to pack what you will important for the weather instead of packing everything. This time of year it is typically cold nights and cool days so preparing to dress in layers is the best way to go. It appears that this weekend is not going to be very cold but will be a bit windy. Therefor dressing for the wind will be important.

So now that know the type of gear and clothing I will need to bring the next step will be creating a list so forgetting to pack key items is a good idea. Being only 2 nights and a full day and a half of fishing its easy to pack light. All of my fishing tackle and rods are already packed due to previous fishing trips so that cuts out about half of things needed. It is fall so i will need to pack warmer clothing and my semi dry gear. Rule of thumb is water + Air temperature must reach a minimum of 120 degrees or falling into the water could be deadly without the protective dry gear.

I am also looking forward to using my Torqeedo as this is a special place with a 4-5 knot tide at fall new moon. Its going to be ripping and windy. challenge accepted! I will be targeting Striped Bass Blue Fish Speckled Trout and Tautog.

The Jamboree is held in Cape May NJ which is a two hour drive from my home. It is ground zero for some of the best Tautog fishing on the East Coast.

A nice drive south on the Garden State Parkway through the Pine Barens. Looking forward to meeting up with a lot of familiar faces and meeting new anglers! Im also looking forward to doing a little celebrating as today is my birthday!!

Hope to see you all there at the captains meeting tonight!

If not I will be on campsite 729.
For more information see http://jckf-forum.forumotion.net/

I have seen this question posted here and there and I have the answer for you! The best way to Mount the Torqeedo 403 Throttle Controller is using a RAM Mount. Then go to your local Hardware store and match the threads to a Stainless Steel screw and mount it to the diamond base RAM ball.  Now you have plenty of mounting options!

RAMS

RAM Mounts you’ll need

RAP-B-201U Composite Double Socket Arm that will receive a 1″ ball

RAM-B-238U RAM 2.43″ x 1.31″ Diamond Ball Base with 1″ Ball

Screws needed for ball to controller mounting Metric M4-0.7 x 20mm stainless steel screws

Mounting to Kayak

RAP-B-375U Tbolt Screwball for Track Systems

RAP-B-379U-252050-KAY1  RAM 1″ Tough-Ball™ with 1/4″-20 X .50″ Male Threaded Post for Kayaks

OR

RAP-B-354U-TRA1 Track Ball with T-Bolt Attachment

http://www.rammount.com/part/RAP-B-354U-TRA1

Enjoy!

 

Controller_Mounted

 

Other Torqeedo Posts:

403 ultralight

403 ultralight complete freature

403 ultralight post freature2

 

footbrace FI (Mobile)

 

Page 3 of 181234510...Last »
%d bloggers like this: