This custom install is a pretty cool one! With bigger boats who doesn’t want that extra oomph of a Ultralight 403 behind them! Coming in at 145 lbs the Titan Propel is a Beast! Yes being a pedal drive boat has its advantages but why not get to your favorite bass hole quicker?
The install utilizes Sealect Designs Tru-Course steering footbraces like all of my installs has an advantage. The ability to steer with your feet and not use your hand to control a rudder knob is key!
In conjunction with Delaware Paddlesports I was able to complete this amazing Torqeedo Ultralight 403/AC install. Neil S took alot of time and reasearch for his complete install. He had many great ideas as he attempted to do a Drill Free motor install on his Hobie PA 12. We took a look at it and Neil allowed me to Drill 8 Small holes in his beloved Hobie. Here are the results!
Utilizing Sea-lect Designs Tru-Course Steering footbraces we were able to make the Hobie Pro Angler Torqeedo 403 completely Hands Free steering. I have done many installs in the past which integrated the Torqeedo with the Rudder hand steering of the Pro Angler. This is a great option for most users. However can be limited.
Plumbing the Hobie Pro Angler is pretty Simple. Drilling holes using 15/64″ drill bit for rudder tubing. This will make the hole tight on the tubing and should not require any silicone to seal although it is not below the waterline. Run cables. Secure tubing with wire clamps. I used the existing mesh pocket screws and the 2 screws beside the seat that hold the foam in place.
The footbraces are mounted below the ridge 1 1/2″ to the top. This requires a 1/4″ drill. Center the motor and using the foot brace small hex keys provided to center the foot pedals. Then tighten and swadge or cable clamp the ends. We cut back the top rail plates to allow the foot braces to operate freely.
Utilizing the new Torqeedo Ultralight Kayak Mount here is images of Rick W’s upgrade install. Rick was previously using the Torqeeod Ultralight 403 Ball mount system. Since his 2014 Big Rig has the four molded in inserts at the stern designed to accept the Power Pole Micro anchoring system the installation was done with ease.
“Once I figured out how I wanted to secure, it was pretty straight forward. I used 1.5 inch screws in front holes and secured the level with locknut underneath. Sets correct heights and makes mount very stable. Second set of holes was 1.25 inch screws, no need for nut as the mount rests on the hull in very back. Perfect fit with single washer on top. As far as steering, I dropped the triangle a bit and let the connectors run under the mount. Seems to work perfect and stays clear of the mount, even with complete turn radius. I use foot turning, installed with initial setup a few years back. Tremendous improvement over the arm and am ready for the water.”
Nice work Rick! Looks Great!