A few new modifications to the Torqeedo steering system. First of all I purchased an aftermarket anodized aluminum steering bracket which is sold by The Kayak Fishing Store. It was fabricated to replace the stock plastic bracket. There has been issues with the stock bracket breaking when under stress of steering and torque from the motor. The aluminum bracket is much more rigid being made out of metal and most likely will last a life time if properly cared for.
The next upgrade is a stainless steel quick release 3/16″ closed eye spring clip for the steering cables that connect to the steering bracket. This clip enables the attach and detaching of the steering bracket in seconds instead of the previous setup using the pin and split ring.
This modification was easy. Simply take the existing cable ends off by removing the cotter pin and slide the cable out. You will now clamp down the foot brace track so it is aligned with the track (centered). Clip the new spring clip to the steering bracket on the Torqeedo. Slide a 3 inch piece of 1/4″ heat shrink tubing on the cable. Then feed the end of the cable through one side of the cable crimp. You will now feed the cable through the eye on the clip and back through the other side of the crimp. Center the motor and slide the crimp up so there is around 3/8″ – 1/2″ diameter loop. make sure the cable is tight going to the foot brace. Crimp with a pair of heavy duty pliers and repeat the same steps for the opposite side.
Once this step is completed it should look like Figure A below.
Figure B above illustrates the completed modification with the heat shrink tubing.
The links below will direct you to the parts.
There will be other modifications in the future. Please check back to The Plastic Hull for mods and subscribe for instant emails on new posts.
